Disable log output – Allied Telesis AT-S63 User Manual
Page 232
Chapter 14: Event Log and Syslog Client Commands
232
Section II: Advanced Operations
DISABLE LOG OUTPUT
Syntax
disable log output[=
output-id
]
Parameters
output
Specifies the output definition ID number to disable.
Not specifying an output definition disables all
definitions.
Description
This command disables an output definition. When disabled, no event
messages are sent to the specified device, although the definition still
exists. To permanently remove an output definition, see “DESTROY LOG
OUTPUT” on page 230. To enable the output definition again, see
“ENABLE LOG OUTPUT” on page 234.
Example
The following command disables (but does not delete) output definition
number 7:
disable log output=7
The following command disables all configured definitions:
disable log output