Allied Telesis AT-S63 - Manual (Page 570)

Chapter 33: Internet Protocol Version 4 Packet Routing Commands
570 Section VII: Internet Protocol Routing
ENABLE IP ROUTE MULTIPATH
Syntax
enable ip route multipath
Parameters
None.
Description
This command enables the ECMP feature. When this feature is enabled,
the routing table in the switch routes packets to a specific remote
destination using more than one route when the table contains multiple
static or dynamic routes to the destination. The table can contain up to 32
routes to the same destination and up to eight of the routes can be active
at one time. The default setting for ECMP is enabled. To view the current
status of ECMP on the switch, use the SHOW IP ROUTE command with
the GENERAL parameter. For instructions, refer to “SHOW IP ROUTE” on
page 592.
Example
The following example enables ECMP on the switch:
enable ip route multipath