Allied Telesis AT-S63 - Manual (Page 619)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 619
SHOW VRRP
Syntax
show vrrp=[ vrid |all]
Parameters
vrrp Specifies the ID of the virtual router. The options are:
vrid Specifies the ID of a single virtual router,
a number between 1 and 255.
all Specifies that all the virtual routers in
which the switch participates be enabled.
Description
This command displays information about a specific virtual router of all the
virtual routers in which the switch is participating.
Figure 56 is an example of the information displayed by this command.
Figure 56. SHOW VRRP Command
Virtual Router Identifier .................1
Configuration
VR MAC Address ..................... 00-00-5R-00-01-01
Interface .......................... VLAN
Priority ........................... 34
State .............................. Backup
Authentication ..................... Plaintext
Password ........................... Set
IP Address(es) ..................... 34.12.163.156
Advertisement Interval ............. 1
Preempt Mode ....................... ON
Preempt Delay (seconds) ............ 60
Original Priority .................. 34
Port Monitoring .................... ON
Step Value ......................... 40
Port Reset ......................... ON
Monitored Interfaces
Interface .......................... VLAN
New Priority ...................... 40
Counters
Good Advertisements Received ....... 0
Bad Advertisements Received ........ 0
Master Periods ..................... 1
Advertisements Sent ................ 0