Allied Telesis AT-S63 - Manual (Page 331)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 331
SET DOS IPOPTION
Syntax
set dos ipoption port= port state=enable|disable
[mirroring=yes|no|on|off|true|false|enabled|disabled]
Parameters
port Specifies the switch port where you want to enable or
disable the IP Option defense. You can specify more
than one port at a time.
state Specifies the state of the IP Option defense. The
options are:
enable Activates the defense.
disable Deactivates the defense. This is the default.
mirroring Specifies whether the examined traffic is copied to a
mirror port. Options are:
yes, on, true Traffic is mirrored. These values are
enabled equivalent.
no, off, false Traffic is not mirrored. This is the
disabled default. These values are equivalent.
Description
This command enables and disables the IP Option DoS defense.
This type of attack occurs when an attacker sends packets containing bad
IP options to a victim node. There are many different types of IP options
attacks and the AT-S63 Management Software does not try to distinguish
between them. Rather, a switch port where this defense is activated
counts the number of ingress IP packets containing IP options. If the
number exceeds 20 packets per second, the switch considers this a
possible IP options attack and does the following occurs:
ˆ The switch sends a trap to the management stations.
ˆ The switch blocks all traffic on the port for one minute.
This defense mechanism does not involve the switch’s CPU. You can
activate it on as many ports as you want without it impacting switch
performance.