Allied Telesis AT-S63 - Manual (Page 524)

Chapter 30: GARP VLAN Registration Protocol Commands
524 Section VI: Virtual LANs
SET GARP TIMER
Syntax
set garp=gvrp timer [default] [jointime= value ]
[leavetime= value ] [leavealltime= value ]
Parameters
garp Specifies the GARP application to be configured.
GVRP is the only GARP application supported by the
AT-9400 Switch.
default Returns the GARP timers to their default settings.
jointime Specifies the Join Timer in centiseconds, which are
one hundredths of a second. The default is 20 centi
seconds.
If you change this timer, it must be in relation to the
GVRP Leave Timer according to the following
equation:
Join Timer <= (2 x (GVRP Leave Timer))
leavetimer Specifies the LeaveTimer in centiseconds, which are
one hundredths of a second. The default is 60 centi
seconds.
leavealltime Specifies the LeaveAllTimer in centiseconds. The
default is 1000 centiseconds.
Note
The online help for this command contains an STP option. This
option is not supported.
Description
This command sets the GARP timers.
Note
The settings for these timers must be the same on all GVRP-active
network devices.