Allied Telesis AT-S63 - Manual (Page 426)

Chapter 25: SNMPv3 Commands
426 Section IV: SNMPv3
SET SNMPV3 NOTIFY
Syntax
set snmpv3 notify= notify tag= tag [type=trap|inform]
[storagetype=volatile|nonvolatile]
Parameters
notify Specifies the name associated with the trap
message, up to 32 alphanumeric characters.
tag Specifies the notify tag name, up to 32
alphanumeric characters.
type Specifies the message type. Options are:
trap Trap messages are sent, with no
response expected from the host.
inform Inform messages are sent, with a
response expected from the host.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table
entry to the configuration file on the
switch. This is the default.
nonvolatile Allows you to save the table entry to
the configuration file on the switch.
Description
This command modifies an SNMPv3 Notify Table entry.
Examples
The following command modifies an SNMPv3 Notify Table entry called
“systemtesttrap2.” The notify tag is “systemtesttag2” and the message
type is a trap message.
set snmpv3 notify=systemtesttrap2 tag=systemtesttag2
type=trap