Allied Telesis AT-S63 - Manual (Page 52)

Chapter 2: Basic Switch Commands
52 Section I: Basic Operations
SET SYSTEM
Syntax
set system [name=" name "] [contact=" contact "]
[location=" location "]
Parameters
name Specifies the name of the switch. The name can be from 1 to
39 alphanumeric characters in length and must be enclosed
in double quotes (“ “). Spaces are allowed.
contact Specifies the name of the network administrator responsible
for managing the switch. The contact can be from 1 to 39
alphanumeric characters in length and must be enclosed in
double quotes. Spaces are allowed.
location Specifies the location of the switch. The location can be from
1 to 39 alphanumeric characters in length and must be
enclosed in double quotes. Spaces are allowed.
Description
This command sets a switch’s name, the name of the network
administrator responsible for managing the unit, and the location of the
unit.
If a parameter already has a value, the new value replaces the existing
value. To view the current values for these parameters, refer to “SHOW
SYSTEM” on page 63. To delete a value without assigning a new value,
refer to “RESET SYSTEM” on page 44.
Note
If you define the system name before you set up a system prompt,
the switch uses the first 16 characters of the system name as the
prompt. See “SET PROMPT” on page 36.
Examples
The following command sets a switch’s information:
set system name="Sales" contact="Jane Smith" location="Bldg
3, rm 212"
The following command sets just the system’s name:
set system name="PR Office"