Allied Telesis AT-S63 - Manual (Page 81)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 81
SET TIME
Syntax
set time= hh:mm:ss
Parameter
time Specifies the hour, minute, and second for the switch’s
time in 24-hour format.
Description
This command sets the time on the switch. You can use this command to
set the switch’s time if you are not using an SNTP server. With its onboard
battery, the AT-9400 Switch can maintain the time even when the unit is
powered off or reset.
Example
The following command sets the switch’s time to 4:34 pm and 52 seconds:
set time=16:34:52