Allied Telesis AT-S63 - Manual (Page 260)

Chapter 15: Classifier Commands
260 Section II: Advanced Operations
SHOW CLASSIFIER
Syntax
show classifier[= idnumber ]
Parameters
classifier Specifies the ID of the classifier you want to view. You can
specify more than one classifier at a time.
Description
This command displays the classifiers on a switch. Figure 24 is an
example of the information displayed by this command.
Figure 24. SHOW CLASSIFIER Command
The information displayed by this command is described here:
ˆ ID - The classifier’s ID number.
ˆ Description - The description of the classifier.
ˆ The Description is followed by the parameter settings of the classifier.
Only those parameters that have been assigned a value are displayed.
For an explanation of the parameters, refer to “CREATE CLASSIFIER”
on page 252 or “SET CLASSIFIER” on page 257.
ˆ Number of References - The number of active and inactive ACL and
QoS policy assignments where the classifier is currently assigned. An
active ACL or QoS policy is assigned to at least one switch port while
an inactive ACL or policy is not assigned to any ports. If this number is
0 (zero), the classifier has not been assigned to any ACLs or policies.
---------------------------------------------
Classifier ID: .................. 1
Description: .................... IP traffic
Protocol: ....................... 0x800 (IP)
Number of References: ........... 4
Number of Active Associations: .. 3
---------------------------------------------
Classifier ID: .................. 2
Description: .................... subnet 214
Dst IP/Mask: .................... 169.254.44.214
Number of References: ........... 1
Number of Active Associations: .. 1
---------------------------------------------