Rockwell Automation 1336S Plus FRN 1.xx-5.xx User Manual
Page 121
5–43
Programming
This group of parameters contains the parameters needed for an optional communications
adapter to communicate with the drive.
Adapter I/O
These parameters determine the parameter number
to which PLC output data table or SCANport device
image information will be written. Refer to the A-B
Single Point Remote I/O Adapter manuals or other
SCANport device manual for data link information.
[Data In A1]
[Data In A2]
[Data In B1]
[Data In B2]
[Data In C1]
[Data In C2]
[Data In D1]
[Data In D2]
Parameter Number
111-118
Parameter Type
Read and Write
Display Units / Drive Units
Parameter # / Parameter #
1336 PLUS
SCANport Device
These parameters determine the parameter number
whose value will be read into the PLC input data
table or SCANport device image. Refer to the A-B
Single Point Remote I/O Adapter manuals or other
SCANport device manual for data link information.
[Data Out A1]
[Data Out A2]
[Data Out B1]
[Data Out B2]
[Data Out C1]
[Data Out C2]
[Data Out D1]
[Data Out D2]
Parameter Number
119-126
Parameter Type
Read and Write
Display Units / Drive Units
Parameter # / Parameter #
1336 PLUS
SCANport Device