Rockwell Automation 1336S Plus FRN 1.xx-5.xx - Manual (Page 49)

Chapter
3
Human Interface Module
Chapter 3 describes the various controls and indicators found on the
optional Human Interface Module (HIM). The material presented in
this chapter must be understood to perform the start-up procedure in
Chapter 4.
When the drive mounted HIM is supplied, it will be connected as
Adapter 1 (see Adapter Definitions in Chapter 2) and visible from
the front of the drive. The HIM can be divided into two sections;
Display Panel and Control Panel. The Display Panel provides a
means of programming the drive and viewing the various operating
parameters. The Control Panel allows different drive functions to be
controlled. Refer to Figure 3.1 and the sections that follow for a
description of the panels.
!
ATTENTION: When a drive mounted HIM is not
supplied on enclosed NEMA Type 1 (IP 20) drives, the
blank cover plate (option HAB) must be installed to
close the opening in the front cover of the enclosure.
Failure to install the blank cover plate allows access to
electrically live parts which may result in personal
injury and/or equipment damage.
When a drive mounted HIM is supplied with enclosed
NEMA Type 1 (IP 20) drives, but has been removed
from its mounting cradle for remote operation, the blank
cover plate must be installed in place of the HIM.
Important: The operation of some HIM functions will depend upon
drive parameter settings. The default parameter values
allow full HIM functionality.
Figure 3.1
Human Interface Module
Display Panel
Control Panel
Human Interface Module
(HIM)
HIM Description