Rockwell Automation 1336S Plus FRN 1.xx-5.xx - Manual (Page 179)

C–5 CE Conformity
Filter Mounting (continued)
1336 PLUS & FORCE
(Through-the-Wall Mounting)
Frames D & E 2
1336 PLUS & FORCE
(Conventional Mounting)
Frames D & E 2
Conduit Box 1
To Motor 1
Access Panel and
Input Terminal Block
Lower Access Panel
Filter Mounting
Bracket
Filter Mounting
Bracket
Important: Drive and filter must be
mounted to a common back plane with
a positive electrical bond. Spacing is
determined by Conduit Box.
Three-Phase
Input 1
To Motor 1
Three-Phase
Input 1
Conduit Box 1
Nipple/Fitting
1 Input power (source to filter) and output power (filter to drive and drive to motor) wiring must be in conduit or have shielding/armor with equivalent attenuation.
Shielding/armor must be bonded to the metal bottom plate. See requirements 6 & 7 on page C–1.
2 Refer to the Filter Selection table on page C–2 for frame references and corresponding catalog numbers.