Metrohm 757 VA Computrace - Manual (Page 104)

5 Determination mode
757 VA Computrace – Software
94
5.4 Determination curves
Load/save determinations
Determination files ( *.dth ) contain the measurement data and the
determination method used. Existing files can be loaded, saved
again and exported by the following commands:
MAIN WINDOW / File / Load determination
Load an existing determination file into the work-
ing memory. The name of the determination
loaded is displayed in the status bar of the
MAIN
WINDOW .
The current working method is not automatically
overwritten by the determination method, but its
parameters can be copied to the working
method afterwards.
MAIN WINDOW / File / Save determination
Save the current determination loaded in the
working memory. If the determination has been
changed since loading, the message
The file al-
ready exists. Overwrite? appears. Click Yes to
overwrite the determination file or No to cancel
saving.
MAIN WINDOW / File / Save determination as ...
Save the current determination loaded in the
working memory in a new file. Enter name and di-
rectory for storage of the determination file.
MAIN WINDOW / File / Export determination points
Save the measurement points of all sweeps of
the current determination loaded in the working
memory into a data file (extension
*.txt ). This data
file contains a block of the used method parame-
ters followed by the sweep blocks of X and Y val-
ues each preceded by VR number and number
of measurement points. The data files can be
imported into spreadsheet programs like Micro-
soft Excel.
Copy parameters to working method
DETERMINATION CURVES / Edit /
Copy parameters to working method
Copy the parameters of the loaded determination
method into the
WORKING METHOD SPECIFI-
CATIONS window (working method).