Metrohm 757 VA Computrace - Manual (Page 71)

4.3 Exploratory curves
757 VA Computrace – Software
61
Select signal curves
One of the signal curves loaded into the EXPLORATORY CURVES
window is always shown with Selected signal properties which can
be set different from all other curves loaded (see Curve proper-
ties, section 3.5). The selection of this signal file is done in the
Signal field of the EXPLORATORY SPECIFICATION window. An as-
terisk * in this field marks the signal file whose parameters are
loaded in the EXPLORATORY SPECIFICATION window. Only this
signal file can be stored.
Zooming
Curve regions in the EXPLORATORY CURVES window can be en-
larged by zooming the desired area while pressing the left mouse
button ("drag a box"; reset see Auto scaling).
Auto scaling
EXPLORATORY CURVES / Plot / Auto scale (F4)
Reset zooming and scale x and y axes so that all
measurement points of all signal curves are visi-
ble. This function is also active during measure-
ment for the live display.
Swap axes
EXPLORATORY CURVES / Plot / Swap axis / abscissa
Swap x axis for the current signal curve.
EXPLORATORY CURVES / Plot / Swap axis / ordinate
Swap x axis for the current signal curve.
Graphical properties for exploratory curves
EXPLORATORY CURVES / Plot / Page properties
The page properties of the EXPLORATORY
CURVES window can be set with the page tab of
the GRAPHICAL PROPERTIES window (details see
Page properties, section 3.5).
The properties of the x and y axis can be set with
the
x axis and y axis tab of the GRAPHICAL
PROPERTIES window (details see Axis properties,
section 3.5).