Evaluate signal waves, Print signal curves and/or voltammetric parameters – Metrohm 757 VA Computrace User Manual
Page 147
7.3 Signals in exploratory mode
757 VA Computrace – Software
137
5. Set the start and end base points for baseline evaluation by
clicking the buttons of the
Begin
or
End
field.
6. Select
Type
and
Scope
of the baseline.
7. Click the
button. The calculated baselines and
peak maximum positions are displayed in the
EXPLORATORY
CURVES
window. The evaluation results are displayed in the
table of results in the
EXPLORATORY SPECIFICATION
window.
Evaluate signal waves
1. Select the desired signal file in the
Signal
field of the
EX-
PLORATORY SPECIFICATION
window. The selected signal
curve is shown with the
Selected signal properties
.
2. Click on
EXPLORATORY SPECIFICATION
/ Signal / Wave evalua-
tion
. The
WAVE EVALUATION
window is opened.
3. Set the parameters
Minimum width
,
Minimum peak height
and
Smooth factor
for wave evaluation (see Wave evaluation, sec-
tion 4.2).
4. Click the
button. The calculated tangents and
positions of half-wave potentials are displayed in the
EXPLORATORY CURVES
window. The evaluation results are
displayed in the table of results in the
EXPLORATORY
SPECIFICATION
window.
Print signal curves and/or voltammetric parameters
1. Click on
or
MAIN WINDOW
/ File / Print
. The
PRINT EX-
PLORATORY
window is opened.
2. Check the
Print curves
option if the content of the
EXPLORA-
TORY CURVES
window should be printed.
3. Check the
Print voltammetric parameters
option if the parame-
ters in the
EXPLORATORY SPECIFICATION
window should be
printed.
4. Click the
<OK>
button.
5. Select the parameters and properties for printing in the
PRINTER SETUP
window and click the
<OK>
button.