Metrohm 757 VA Computrace - Manual (Page 106)

5 Determination mode
757 VA Computrace – Software
96
Edit determination method parameters
DETERMINATION CURVES / Edit /
Determination method parameters
Open the EDIT DETERMINATION METHOD PARA-
METERS
window for viewing and modifying the
parameters of the determination method used to
record the determination. This window contains
the tabs
Specifications , Determination , Voltammet-
ric , Substances and Calculations . If parameters in
the EDIT DETERMINATION METHOD PARAMETERS
window are changed and <OK> is pressed, the
determination will be recalculated automatically.
Note: These parameters will not automatically be used for the
next measurement. To do this, use the
Copy parameters to working
method command (see section 5.3).
Specifications
The Specifications tab of the EDIT DETERMINATION METHOD
PARAMETERS window contains the main specifications of the de-
termination method. Only Title , Remark1 and Remark2 can be ed-
ited.