Lldp receive – Dell PowerEdge VRTX User Manual
Page 458
458
LLDP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\LLDP.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
Parameters
N/A
Default Configuration
Enabled
Command Mode
Interface (Ethernet) Configuration mode
console(config-if)#
User Guidelines
LLDP manages LAG ports individually. LLDP sends separate advertisements
on each port in a LAG.
LLDP operation on a port is not dependent on the STP state of a port. I.e.
LLDP frames are sent on blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
console(config)# interface gi0/1
console(config-if)# lldp transmit
lldp receive
Use the lldp receive Interface (Ethernet) Configuration mode command to
enable receiving LLDP on an interface. Use the no form of this command to
stop receiving LLDP on an Interface (Ethernet) Configuration mode
interface.
Syntax
lldp receive
no lldp receive
Parameters
N/A