Dell PowerEdge VRTX - Manual (Page 712)

712 IPv6 Tunnel Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\Tunnel New Edition.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
console(config-if)# ipv6 address 3ffe:b00:c18:1::/64 eui-64
console(config-if)# exit
tunnel source
Use the tunnel source Interface Configuration (Tunnel) mode command to
set the local (source) IPv4 address of a tunnel interface. The no form deletes
the tunnel local address.
Syntax
tunnel source {auto | ipv4-address | interface-id }
no tunnel source
Parameters
• auto—The system minimum IPv4 address is used as the local IPv4 address
(IPv4 address of the local tunnel endpoint).
• ip4-address —Specifies the IPv4 address to use as the local IPv4 address
(IPv4 address of the local tunnel endpoint).
• interface-id —Interface which the minimum IPv4 address is used as the
local IPv4 address (IPv4 address of the local tunnel endpoint).
Default
No source address is defined.
Command Mode
Interface (Tunnel) Configuration mode
User Guidelines
If the auto or interface-id option is configured once time chosen IPv4 is used
as the tunnel local IPv4 address until it is defined. A new IPv4 interface is only
chosen in the following cases:
• After reboot.
• The used IPv4 is removed from the switch configuration.
• The tunnel mode is changed.