Dell PowerEdge VRTX - Manual (Page 462)

462 LLDP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Plasma-ARC
2+3\new_system_mifs_ARC2_latest\LLDP.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 3 /1 4 - FO R P R O O F O N LY
changes in the LLDP local systems MIB. Use the no form of this command to
restore the default configuration.
Syntax
lldp tx-delay seconds
no lldp tx-delay
Parameters
tx-delay seconds —Specifies the delay in seconds between successive LLDP
frame transmissions initiated by value/status changes in the LLDP local
systems MIB (range: 1-8192 seconds).
Default Configuration
The default LLDP frame transmission delay is 2 seconds.
Command Mode
Global Configuration mode
User Guidelines
It is recommended that the tx-delay be less than 25% of the LLDP timer
interval.
Example
The following example sets the LLDP transmission delay to 10 seconds.
console(config)# lldp tx-delay 10
lldp optional-tlv
Use the lldp optional-tlv Interface (Ethernet) Configuration mode
command to specify which optional TLVs are transmitted. Use the no form of
this command to restore the default configuration.
For 802.1, see the
lldp optional-tlv 802.1 command.
Syntax
lldp optional-tlv tlv [ tlv2 … tlv5 | none ]