9 canopen connection (only ft-10 co ), Warning – Flintec FT-10xx User Manual
Page 19
FT-10 Smart Process Indicator, Technical Manual, Rev. 1.0, January 2014
Warning:
Connect the shield to the reference ground or shield pin of the power connector.
Warning:
Disconnect IndFace1X PC software before starting Ethernet interfacing.
4.3.9 CANopen Connection (only FT-10 CO )
CANopen connection is done with 4 wires as indicated in Figure 4.13. The data line ends must be equipped
with 120 ohm bus terminating resistors.
Figure 4.13 - FT-10 CO serial interface connections
CANopen Connector pin configuration (DB9M)
Pin
Signal
Description
1
-
-
2
CAN_L
-
3
CAN_GND
-
4
-
-
5
CAN_SHIELD
-
6
-
-
7
CAN_H
-
8
-
-
9
-
-
Housing
Cable Shield
-
Warning:
Connect the shield to the reference ground.
Warning:
Disconnect IndFace1X PC software before starting CANopen interfacing.