Flintec FT-10xx - Manual (Page 29)

FT-10 Smart Process Indicator, Technical Manual, Rev. 1.0, January 2014
[06-] Profinet (Only FT-10 PN)
This sub-block includes the parameters related with the Profinet interfaces of FT-10 indicator.
[060 0] Data Format
0 : Signed 32 bit integer, no decimal point implied
1 : 32 bit float, decimal point implied
[07-] CANopen (Only FT-10 CO)
This sub-block includes the parameters related with the CANopen interfaces of FT-10 indicator.
[070 0] Data Format
0 : Signed 32 bit integer, no decimal point implied
1 : 32 bit float, decimal point implied
[071 000] Rack Address
The CANopen rack address of FT-10 will be entered via keypad between 001 to 126.
5.4.2 Configuration Block [1--]
In this block the parameters take place which are being used to set FT-10 according to your
application.
[11-] Start Up
[112 1] Tare Memory
0 : No. 1 : Tare value is stored at power off.
Note: The parameter [ 202 ] must be selected as 0 to store Tare at power off.
[113 0] Auto Clear Tare
0 : No. 1 : The scale gets back to gross mode after unloading.
[115 ] Key lock
[ ABCDE] When the key lock function is activated, the key(s) programmed as 1 in this parameter
is(are) locked (Page 10).
A: - B: G/N C: Zeroing D: Tare/Clear E: Print
[116 1] Function key
This key function is programmed as;
0 : No any
1 : Increased Indication 2 : Total
3 : Tare value indication 4 : CN value indication 5 : Hold function
6 : Peak function
Explanation: If this parameter selected as total, To clear the weight total, you need to press < Clear >
key while the total value is seen on the display and [ All C ] will appear on the display. You can confirm
deletion by pressing < Enter > key or cancel by pressing < F > key.