Flintec FT-10xx - Manual (Page 42)

FT-10 Smart Process Indicator, Technical Manual, Rev. 1.0, January 2014
General Rules:
1. Commands are only in CAPITAL.
2. CHK (2 ASCII char) can be enabled or disabled from both command and response.
3. Weight data is 8-byte with dot and non-significant zeros on the left.
4. Address (2 ASCII char) will be located in the structure, if not 00.
Command format:
A general description of the command is the following:
[ADR][COMMAND][CHK][CR][LF]
Response format with weight / force :
A general description of the response is the following:
[ADR][COMMAND][STATUS][SIGN][WEIGHT/FORCE][CHK][CR][LF]
Response format without weight / force
[ADR][COMMAND][STATUS][CHK][CR][LF]
Command Table:
A Read all weight data immediately
B Read Gross weight value immediately
C Clear the tare memory
G Read voltage value of DC power supply
I Read current weight (indicated) value immediately
P Print: Read the current stable weight value
Q Load set points
R Read set points
S Read Status
T Tare
U Read digital inputs
V Read digital outputs
W Set/Reset digital outputs
X Read current weight value in increased resolution immediately
Z Zero
Status Table:
A Ack, the command is operated successfully
D Dynamic, unstable weight
E Errors except of H, L, O, +, −.
H High voltage detected
I The weight is in range
L Low voltage detected
N Nack, the command couldn’t be operated
O ADC out
S Stable weight
X Syntax error ( not recognized the received command )
+ Overload
− Underload
Note: CHK, CR and LF will not be shown in below data format descriptions in this section.