Flintec FT-10xx - Manual (Page 41)

FT-10 Smart Process Indicator, Technical Manual, Rev. 1.0, January 2014
6.2 Fast Continuous Data Output
Fast continuous “indicated weight” data output can be used only for the instruments which can communicate
fast. The output rate is related with the baud rate. Use higher baud rate for faster data rate. Received ASCII
codes of P(print), Z(zero), T(tare) or C(clear) letters, the indicator will act like the related keys are pressed.
CR and LF can be enabled in the related parameter.
The data format of the fast continuous data output is;
[STX][STATUS][SIGN][WEIGHT VALUE][CR][LF]
Examples
:
S+000123.4 (weight is stable and 123.4)
D+000123.4 (weight is dynamic and 123.4)
+ (Over load)
- (Under load)
O (ADC out error)
6.3 Print Mode
The format of the data output in Print mode can be selected in 3 different type forms in the parameter group
[ 04- ] . Only continuous format is available in more than one interface.
Single Line
You can send the data in single line like below by pressing < Enter
> key.
CN: 21 G: 3.000kg T: 1.000kg N: 2.000kg
Multi Line
You can send the data in multiple lines as seen in the label given below by pressing < Enter
> key. The data
output structure can be programmed with printer parameters.
Multi Line-1 Format Multi Line-2 Format
6.4 BSI Data Structure
All new generation FLINTEC instruments launched on the market support the standardized command set
BSI data form, depending on the functionality of the instrument. This easy data format gives the reliable and
speedy interface advantages with communicating PLC or PC for process control or transactional
applications. You can expand your system with additional scales from FLINTEC without having to change
your application program base.
CN GROSS TARE NET
M
S
D L
S
D S
P M
S
D L
S
D S
P M
S
D L
S
D S
P M
S
D L
S
D L
F C
R
9 3 13 3 13 3 13 1 1