Monroe Electronics R189se - Manual (Page 101)

- 96 -
1. Log into the One-Net.
2. Go to Encoder > Send EAS > General EAS
3. Set all the standard EAS parameters for RMT, duration, and effective time.
4. Set all the FIPS codes
5. Go to the audio selection pull down menus. There are three pull-down selection menus;
 Optional Pre-Alert Audio Announcement;
 Select Alert Audio Message;
 Optional Post-Alert Audio Announcement
6. Using the Select Alert Audio Message; pull-down select the xxxx-RMT.wav file
 You can select any of the pre-loaded audio files in any of the three locations. The
optional Pre-Alert and Post-Alert selections will bracket the EAS event with audio
messages, HOWEVER if you want it to be part of the EAS message you must select the
audio file using the Select Alert Audio Message pull down.
7. Send the EAS message.
 The audio will be quack, tones, xxxx-RMT.wav, quack
8. Message complete