Monroe Electronics R189se - Manual (Page 67)

- 62 -
Translation File Send
When enabled (checked) the EAS text Translation will be sent as a separate file to
the EAS NET client's remote host. The file name and path on the remote host are
determined by the schema.
Translation File Newline Control
When enabled (checked) the EAS text Translation has all newline characters
removed. When disabled, the EAS text Translation includes newline characters.
Video Start Delay Factor (0-10 seconds)
When set to a non-zero value, this adds delay time to the video start time reported
in the EAS NET event file. This can be useful to handle latency between the One-
Net and the EAS NET remote host.
Duration Extension Time (seconds)
This allows extra time to be added to the internally calculated duration time in the
EAS NET event file. Alert Duration == Audio Duration + Extension Time
All FIPS codes trigger
If enabled, all alert FIPS codes will trigger the EAS NET client interface. In the next
screen shot this option is disabled. Set the checkbox to enable/disable FIPS code
filtered trigger control. If disabled, then the alert FIPS codes are filtered for at least
one specific match as a way to control whether or not EAS NET is triggered. Alerts
for specific FIPS areas can be filtered as a way to control whether or not EAS NET is
triggered. If All FIPS is disabled, select FIPS codes from the provided Encoder FIPS
pool or the Forwarding FIPS pool lists and add to the client FIPS list. If any of these
FIPS are included in the incoming active forwarded/originated alert, the alert will be
sent using the EAS NET client. With careful use of this feature, and with multiple
clients, one One-Net can serve many different cable regions at the same time.
Setup > Net Alerts > EAS_NET Client Configuration > FIPS trigger interface
All EAS codes trigger