Monroe Electronics R189se - Manual (Page 82)

- 77 -
Select the condition to close each relay that is required. Once that is selected the
Activating FIPS and Activating EAS Codes boxes will be displayed. The default setting
is “Any FIPS” and “Any EAS Codes” which triggers the relay when an alert is detected.
Setup > Net Alerts > Hub Controller: FIPS and EAS Codes
Relay activation can be programmed so that they only close when Alerts for specific
FIPS areas or EAS codes are present. Click on the “Edit FIPS” button to select FIPS
codes from the FIPS pools. When the desired FIPS codes are selected click the “Add
FIPS selected above to the list” and they will be added to the FIPS list to the right. When
finished, click on the “FIPS Editing Finished” button. Repeat this step for all of the
required relays. The same process is used for editing the activating EAS codes.