Monroe Electronics R189se - Manual (Page 35)

- 30 -
4.5 Setup > Email
The One-Net
SE
can be configured to optionally send email upon alert decoding, origination,
and forwarding. Select the Setup > Email page to configure an outgoing email server and to
configure the send options. There are four tabbed sections: Email Server, Event Email,
Decoder Email, and Encoder Email.
4.5.1 Email Server
To set the outgoing email server name without using authentication (port 25):
 Select Setup Email >Email Server. From this page you can set the name of the
SMTP server for outgoing Emails from the One-Net
SE
. Enter a name in the text
field after Outgoing Email Server and click Set & Test Mail Server Name.
 The One-Net SE
will attempt to contact this Email server.
 If it succeeds, the message "OK: Contacted Email Server" will display under the
name.
To test if Email can actually be sent via the chosen Email server, type a valid Email
address in the To: text field and click Send Test Email. If this works, the chosen recipient
should receive an Email.
Setup > Email > Email Server: Not using authentication
To set the outgoing email server name using authentication (port 587):
 Select Setup Email >Email Server. From this page you can set the name of the
SMTP server for outgoing Emails from the One-Net
SE
.
 Enable the Use Authentication? Option.
 Provide a username and password for authentication.