Monroe Electronics R189se - Manual (Page 46)

- 41 -
Alert Encoding Audio Configuration
When the One-Net
SE
encoder is used to originate an EAS alert, the audio associated with
the alert must be played out of an output port in order for the alert to be transmitted or
decoded by another decoder. The audio for the alert must be configured to play over a
selected audio output. This interface allows for enabling/disabling Originating audio
on each of the audio output devices. Enabling/disabling is achieved using the
provided checkbox toggles. The text next to the toggles clearly indicates the current
state and the result of toggling. The audio output levels are also displayed and provide an
active hyperlink to the Audio Output Levels/Tests page to change the output levels.
Changes are effective immediately.
Select audio device for alert audio encoding microphone:
The One-Net
SE
encoder provides an interface to record audio into WAV files. These can
then be used for the audio portion of an alert. This page provides for selecting which
audio device is used for the microphone input source. The Main audio device or any
Auxiliary Audio device with a microphone input can be selected for use during alert
audio recording. Use the provided radio button to select the microphone. Use the Mic
Input Level control to set the level for the microphone. Changes do not take place until
Accept Changes is clicked.