Monroe Electronics R189se - Manual (Page 26)

- 21 -
2
nd
Network
There is a 2
nd
network interface that comes standard with the One-Net
SE
. Programming
the 2
nd
NIC is done by first enabling the 2
nd
NIC by clicking on the box to the left of the
“Second Network Interface”. If an external NIC is seen by the One-Net
SE
, the setup box
will turn green. The setup boxes are exactly the same as the first NIC. A static address,
DHCP, and a gateway route can be used.
Setup > Network > Configuration: 2
nd
NIC
3
rd
and 4
th
Network
If the optional NIC daughter board was purchased with your One-Net
SE
, you will have
the ability to enable a 3
rd
and 4
th
network interface. The setup is the same as the first two
networks except for the fact that DHCP is not supported. A static IP address must be
used.