Monroe Electronics R189se - Manual (Page 32)

- 27 -
Setup > Time
One-Net
SE
Date and Time Configuration
Make changes to date and/or time and/or time zone, and then click Submit changes. If Time
zone is changed, the One-Net
SE
will restart and you will be forced to log back into the Web
interface. If the time is set forward far enough, you will also be forced to log back into the
One-Net
SE
Web interface.
Network Time Protocol (NTP) Configuration
The One-Net
SE
supports Network Time Protocol (NTP) to synchronize its clock to another
clock over a network. This will synchronize the One-Net
SE
to an atomic clock over the
Internet, or to another computer running NTP on your LAN, or to another One-Net
SE
running
as an NTP server on your LAN.
NTP Server name or IP Address:
You must enter a name of a remote NTP server that is accessible from the One-Net
SE
LAN.
Public NTP servers can be viewed by following the link provided.
NOTE: The computer hosting the Web browser must have Internet access
to follow this link, and the One-NetSE must be able to contact the chosen
NTP server.