Artesyn MOTLoad Firmware Package User's Manual (February 2015) - Manual (Page 44)

MOTLoad Commands
MOTLoad Firmware Package User’s Manual (6806800C24D) 44
3.1.4 bdTempShow
Name
bdTempShow—displays the current board temperature(s). The information displayed may
vary dependent upon the hardware.
Synopsis
bdTempShow
Parameters
none
Example
The following example shows a typical result of entering the bdTempShow command:
MOTLoad>
bdTempShow
Cpu TAU Temp=030C Therm Sensor = 27.0C
MOTLoad>
The TAU value has a variation of 25C; however, the DS1621 thermal sensor has an accuracy
of 0.5C. This sensor is usually located on the secondary side of the board, centered near the
lower edge.
See Also