ACTi XNR-4200 V1.02.13 - Manual (Page 79)

www.acti.com
XNR-4200 User’s Manual 1.02.13
79
PTZ
The PTZ setting page will only display for a PTZ / Speed dome model.
On this page, you can configure all the PTZ related settings and use-on screen PTZ control.
1. Enable/Disable PTZ: Click this to enable or disable the PTZ function of this device.
2. Address ID: Enter the address ID of the PTZ device / speed dome.
3. Vendor: Select the vendor of the PTZ device/ speed dome you wish to control. You may
select the device type directly if it is listed here.
4. Protocol: Select the protocol of the PTZ device/ speed dome.
5. Parity: Enter the parity of the PTZ device / speed dome.
6. Baud Rate: Enter the baud rate of the PTZ device/ speed dome. This option appears
only for certain models.