H3C Technologies H3C S10500 Series Switches - Manual (Page 225)

210
Task Remarks
Enabling MSDP Required
Creating an MSDP peer connection Required
Configuring basic functions
of MSDP
Configuring a static RPF peer Optional
Configuring MSDP peer description Optional
Configuring an MSDP mesh group Optional
Configuring an MSDP peer
connection
Configuring MSDP peer connection control Optional
Configuring SA message content Optional
Configuring SA request messages Optional
Configuring SA message filtering rules Optional
Configuring SA messages
related parameters
Configuring the SA cache mechanism Optional
Configuring basic functions of MSDP
NOTE:
All the configuration tasks should be carried out on RPs in PIM-SM domains, and each of these RPs acts as
an MSDP peer.
Configuration prerequisites
Before you configure the basic functions of MSDP, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer
• Configure PIM-SM to enable intra-domain multicast forwarding
• Determine the IP addresses of MSDP peers
• Determine the address prefix list for an RP address filtering policy
Enabling MSDP
Enabling MSDP globally for the public network
Follow these steps to enable MSDP globally for the public network:
To do... Use the command... Remarks
Enter system view system-view —
Enable IP multicast routing multicast routing-enable
Required
Disabled by default
Enable MSDP and enter public
network MSDP view
msdp
Required
Disabled by default