H3C Technologies H3C S10500 Series Switches - Manual (Page 233)

218
• An MSDP peering relationship is set up between the RPs of the PIM-SM domains to share multicast
source information among the PIM-SM domains.
Figure 62 Network diagram for PIM-SM inter-domain multicast configuration
Vl
an
-int103
Vl
an
-int103
Vl
an-
int20
0
Vlan-
int30
0
Vl
an-
int40
0
Device Interface IP address Device Interface IP address
Switch A Vlan-int103 10.110.1.2/24 Switch D Vlan-int104 10.110.4.2/24
Vlan-int100 10.110.2.1/24 Vlan-int300 10.110.5.1/24
Vlan-int200 10.110.3.1/24 Switch E Vlan-int105 10.110.6.1/24
Switch B Vlan-int103 10.110.1.1/24 Vlan-int102 192.168.3.2/24
Vlan-int101 192.168.1.1/24 Loop0 3.3.3.3/32
Loop0 1.1.1.1/32 Switch F Vlan-int105 10.110.6.2/24
Switch C Vlan-int104 10.110.4.1/24 Vlan-int400 10.110.7.1/24
Vlan-int102 192.168.3.1/24 Source 1 — 10.110.2.100/24
Vlan-int101 192.168.1.2/24 Source 2 — 10.110.5.100/24
Loop0 2.2.2.2/32
Configuration procedure
1. Configure IP addresses and unicast routing
Configure the IP address and subnet mask for each interface as per Figure 62 . (details not shown)
Configure OSPF for interconnection between switches in each AS. Ensure the network-layer
interoperation among each AS, and ensure the dynamic update of routing information between the
switches through a unicast routing protocol. (details not shown)
2. Enable IP multicast routing, enable PIM-SM on each interface, and configure a PIM-SM domain
border
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and enable IGMP on the
host-side interface VLAN-interface 200.
<SwitchA> system-view
[SwitchA] multicast routing-enable