H3C Technologies H3C S10500 Series Switches - Manual (Page 400)

385
Task Remarks
Disabling BSM semantic fragmentation Optional
Enabling IPv6 administrative scoping Optional
Configuring an IPv6 admin-scope zone boundary Optional
Configuring IPv6 administrative
scoping
Configuring C-BSRs for each admin-scope zone Optional
Configuring IPv6 PIM common features Optional
Configuration prerequisites
Before you configure IPv6 BIDIR-PIM, complete the following tasks:
• Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain can communicate with each other at Layer 3.
• Determine the IPv6 address of a static RP and the IPv6 ACL that defines the range of IPv6 multicast
groups to be served by the static RP.
• Determine the C-RP priority and the IPv6 ACL that defines the range of IPv6 multicast groups to be
served by each C-RP.
• Determine the legal C-RP address range and the IPv6 ACL that defines the range of IPv6 multicast
groups to be served.
• Determine the C-RP-Adv interval.
• Determine the C-RP timeout.
• Determine the C-BSR priority.
• Determine the hash mask length.
• Determine the IPv6 ACL defining the legal BSR address range.
• Determine the BS period.
• Determine the BS timeout.
Enabling IPv6 PIM-SM
You must enable IPv6 PIM-SM before enabling IPv6 BIDIR-PIM because IPv6 BIDIR-PIM is implemented on
the basis of IPv6 PIM-SM. To deploy an IPv6 BIDIR-PIM domain, enable IPv6 PIM-SM on all non-border
interfaces of the domain.
Follow these steps to enable IPv6 PIM-SM:
To do... Use the command... Remarks
Enter system view system-view —
Enable IPv6 multicast routing multicast ipv6 routing-enable
Required
Disabled by default.
Enter interface view
interface interface-type
interface-number
—
Enable IPv6 PIM-SM pim ipv6 sm
Required
Disabled by default.