H3C Technologies H3C S10500 Series Switches - Manual (Page 421)

406
Figure 106 Network diagram for IPv6 PIM-SM non-scoped zone configuration
Ether
net
Ether
net
E
thernet
Source
4001::100/64
IPv6 PIM-SM
Switch A
Switch B
Switch C
Switch D
Receiver
Host A
Host B
Host C
Host D
Receiver
N1
N2
Switch E
Vlan-int100
Vlan-int200
Vlan-int200
Vlan-int300
Vlan-int102
Vlan-int102
Vlan-
in
t1
01
Vlan-
int10
1
Vlan-int103
Vlan-int103
Vlan-int104
Vlan-int104
Vlan-int105
Vlan-int105
Device Interface IPv6 address Device Interface IPv6 address
Switch A Vlan-int100 1001::1/64 Switch D Vlan-int300 4001::1/64
Vlan-int101 1002::1/64 Vlan-int101 1002::2/64
Vlan-int102 1003::1/64 Vlan-int105 4002::1/64
Switch B Vlan-int200 2001::1/64 Switch E Vlan-int104 3001::2/64
Vlan-int103 2002::1/64 Vlan-int103 2002::2/64
Switch C Vlan-int200 2001::2/64 Vlan-int102 1003::2/64
Vlan-int104 3001::1/64 Vlan-int105 4002::2/64
Configuration procedure
1. Enable IPv6 forwarding and configure IPv6 addresses and IPv6 unicast routing.
Enable IPv6 forwarding on each switch and configure the IPv6 address and prefix length for each
interface as per Figure 106 . (Details not shown)
Configure OSPFv3 on the switches in the IPv6 PIM-DM domain to ensure network-layer reachability
among them. (Details not shown)
2. Enable IPv6 multicast routing, and enable IPv6 PIM-SM and MLD.
# Enable IPv6 multicast routing on Switch A, enable IPv6 PIM-SM on each interface, and enable MLD on
VLAN-interface 300, which connects Switch A to N1.
<SwitchA> system-view
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] pim ipv6 sm
[SwitchA-Vlan-interface100] quit