H3C Technologies H3C S10500 Series Switches User Manual

Page 240

Advertising
background image

225

[SwitchF-bgp] peer 10.110.4.1 as-number 100

[SwitchF-bgp] import-route ospf 1

[SwitchF-bgp] quit

# Redistribute BGP routing information into OSPF on Switch B.

[SwitchB] ospf 1

[SwitchB-ospf-1] import-route bgp

[SwitchB-ospf-1] quit

# Redistribute BGP routing information into OSPF on Switch D.

[SwitchD] ospf 1

[SwitchD-ospf-1] import-route bgp

[SwitchD-ospf-1] quit

# Redistribute BGP routing information into OSPF on Switch C.

[SwitchC] ospf 1

[SwitchC-ospf-1] import-route bgp

[SwitchC-ospf-1] quit

# Redistribute BGP routing information into OSPF on Switch F.

[SwitchF] ospf 1

[SwitchF-ospf-1] import-route bgp

[SwitchF-ospf-1] quit

5.

Configure MSDP peers and static RPF peers

# Configure Switch D and Switch G as the MSDP peers and static RPF peers of Switch A.

[SwitchA] ip ip-prefix list-dg permit 10.110.0.0 16 greater-equal 16 less-equal 32

[SwitchA] msdp

[SwitchA-msdp] peer 10.110.3.2 connect-interface vlan-interface 101

[SwitchA-msdp] peer 10.110.6.2 connect-interface vlan-interface 102

[SwitchA-msdp] static-rpf-peer 10.110.3.2 rp-policy list-dg

[SwitchA-msdp] static-rpf-peer 10.110.6.2 rp-policy list-dg

[SwitchA-msdp] quit

# Configure Switch A as the MSDP peer and static RPF peer of Switch D.

[SwitchD] ip ip-prefix list-a permit 10.110.0.0 16 greater-equal 16 less-equal 32

[SwitchD] msdp

[SwitchD-msdp] peer 10.110.1.1 connect-interface vlan-interface 103

[SwitchD-msdp] static-rpf-peer 10.110.1.1 rp-policy list-a

[SwitchD-msdp] quit

# Configure Switch A as the MSDP peer and static RPF peer of Switch G.

[SwitchG] ip ip-prefix list-a permit 10.110.0.0 16 greater-equal 16 less-equal 32

[SwitchG] msdp

[SwitchG-msdp] peer 10.110.2.1 connect-interface vlan-interface 106

[SwitchG-msdp] static-rpf-peer 10.110.2.1 rp-policy list-a

[SwitchG-msdp] quit

6.

Verify the configuration

Use the display bgp peer command to view the BGP peering relationships between the switches. If the

command gives no output information on Switch A, it means that no BGP peering relationship has been
established between Switch A and Switch D, or between Switch A and Switch G.

Advertising