H3C Technologies H3C S10500 Series Switches User Manual
Page 422
407
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim ipv6 sm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim ipv6 sm
[SwitchA-Vlan-interface102] quit
The configuration on Switch B and Switch C is similar to that on Switch A. The configuration on Switch D
and Switch E is also similar to that on Switch A except that it is not necessary to enable MLD on the
corresponding interfaces on these two switches.
3.
Configure a C-BSR and a C-RP.
# On Switch D, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and set the
hash mask length to 128 and the priority of the C-BSR to 10.
<SwitchD> system-view
[SwitchD] acl ipv6 number 2005
[SwitchD-acl6-basic-2005] rule permit source ff0e::101 64
[SwitchD-acl6-basic-2005] quit
[SwitchD] pim ipv6
[SwitchD-pim6] c-bsr 4002::1 128 10
[SwitchD-pim6] c-rp 4002::1 group-policy 2005
[SwitchD-pim6] quit
# On Switch E, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and set the
hash mask length to 128 and the priority of the C-BSR to 20.
<SwitchE> system-view
[SwitchE] acl ipv6 number 2005
[SwitchE-acl6-basic-2005] rule permit source ff0e::101 64
[SwitchE-acl6-basic-2005] quit
[SwitchE] pim ipv6
[SwitchE-pim6] c-bsr 1003::2 128 20
[SwitchE-pim6] c-rp 1003::2 group-policy 2005
[SwitchE-pim6] quit
4.
Verify the configuration.
Use the display pim ipv6 interface command to view the IPv6 PIM configuration and running status on
each interface. For example:
# View the IPv6 PIM information on all interfaces of Switch A.
[SwitchA] display pim ipv6 interface
Interface NbrCnt HelloInt DR-Pri DR-Address
Vlan100 0 30 1 1001::1
(local)
Vlan101 1 30 1 1002::2
Vlan102 1 30 1 1003::2
To view the BSR election information and the locally configured C-RP information in effect on a switch, use
the display pim ipv6 bsr-info command. For example:
# View the BSR information and the locally configured C-RP information in effect on Switch A.
[SwitchA] display pim ipv6 bsr-info
Elected BSR Address: 1003::2
Priority: 20