H3C Technologies H3C S10500 Series Switches - Manual (Page 304)

289
Figure 73 Network diagram for MLD snooping proxying configuration
Source
Router A
MLD querier
Receiver
Receiver
Host A
Host B
Host C
1::1/64
GE1/0/4
GE1/0/2
GE1/0/3 GE1/0/1
GE1/0/1
2001::1/64 GE1/0/2
1::2/64
VLAN 100
Switch A
Proxy & Querier
Configuration procedure
1. Configure IPv6 addresses for interfaces
Configure an IP address and prefix length for each interface as per Figure 73 . (details not shown)
2. Configure Router A
# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLD on port
GigabitEthernet 1/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] mld enable
[RouterA-GigabitEthernet1/0/1] pim ipv6 dm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim ipv6 dm
[RouterA-GigabitEthernet1/0/2] quit
3. Configure Switch A
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/4 to this VLAN,
and enable MLD snooping and MLD snooping proxying in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 1/0/1 to gigabitethernet 1/0/4
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] mld-snooping proxying enable
[SwitchA-vlan100] quit
4. Verify the configuration