H3C Technologies H3C S10500 Series Switches - Manual (Page 75)

60
[RouterC] multicast routing-enable
[RouterC] interface gigabitethernet 1/0/1
[RouterC-GigabitEthernet1/0/1] pim sm
[RouterC-GigabitEthernet1/0/1] igmp enable
[RouterC-GigabitEthernet1/0/1] quit
[RouterC] interface gigabitethernet 1/0/2
[RouterC-GigabitEthernet1/0/2] pim sm
5. Configure Router D
The configuration on Router D is similar to that on Router C. (details not shown)
6. Configure Switch A
# Enable IGMP snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 1/0/1 through GigabitEthernet 1/0/4 to this VLAN, and
enable IGMP snooping and PIM snooping in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 1/0/1 to gigabitethernet 1/0/4
[SwitchA-vlan100] igmp-snooping enable
[SwitchA-vlan100] pim-snooping enable
[SwitchA-vlan100] quit
7. Verify the configuration
# On Switch A, display the PIM snooping neighbor information of VLAN 100.
[SwitchA] display pim-snooping neighbor vlan 100
Total number of neighbors: 4
VLAN ID: 100
Total number of neighbors: 4
Neighbor Port Expires Option Flags
10.1.1.1 GE1/0/1 02:02:23 LAN Prune Delay
10.1.1.2 GE1/0/2 03:00:05 LAN Prune Delay
10.1.1.3 GE1/0/3 02:22:13 LAN Prune Delay
10.1.1.4 GE1/0/4 03:07:22 LAN Prune Delay
The output shows that Router A, Router B, Router C, and Router D are PIM snooping neighbors.
# On Switch A, display the PIM snooping routing information of VLAN 100.
[SwitchA] display pim-snooping routing-table vlan 100 slot 1
Total 2 entry(ies)
FSM Flag: NI-no info, J-join, PP-prune pending
VLAN ID: 100
Total 2 entry(ies)
(*, 224.1.1.1)
Upstream neighbor: 10.1.1.1
Upstream port: GE1/0/1
Total number of downstream ports: 1
1: GE1/0/3