H3C Technologies H3C S10500 Series Switches - Manual (Page 288)

273
To do... Use the command... Remarks
Enter system view system-view —
Enter Layer 2 Ethernet interface
view, Layer 2 aggregate
interface view, or port group
view
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
Enter port group view:
port-group manual
port-group-name
Required
Use either command
Configure an IPv6 multicast
group filter mld-snooping group-policy
acl6-number [ vlan vlan-list ]
Required
By default, no IPv6 group filter is
configured on an interface. That is, the
hosts on the interface can join any
valid multicast group.
NOTE:
•
When you configure a multicast group filter in an IPv6 multicast VLAN, be sure to configure the filter in
the sub-VLANs of the IPv6 multicast VLAN. Otherwise, the configuration does not take effect.
• In MLDv2, when a host is enabled to join multiple multicast groups, the multicast group filter cannot
correctly filter multicast groups because the host that runs MLDv2 sends multiple multicast groups that it
wants to join in one membership report.
Configuring IPv6 multicast source port filtering
When the IPv6 multicast source port filtering feature is enabled on a port, the port can connect only to
IPv6 multicast receivers rather than multicast sources. The reason is that the port blocks all IPv6 multicast
data packets but it permits multicast protocol packets to pass.
If this feature is disabled on a port, the port can connect to both multicast sources and IPv6 multicast
receivers.
Configuring IPv6 multicast source port filtering globally
Follow these steps to configure IPv6 multicast source port filtering:
To do... Use the command... Remarks
Enter system view system-view —
Enter MLD-snooping view mld-snooping —
Enable IPv6 multicast source port
filtering
source-deny port interface-list
Required
Disabled by default.
Configuring IPv6 multicast source port filtering on a port or a group of ports
Follow these steps to configure IPv6 multicast source port filtering on a port or a group of ports:
To do... Use the command... Remarks
Enter system view system-view —