H3C Technologies H3C S10500 Series Switches - Manual (Page 428)

413
<SwitchC> system-view
[SwitchC] interface vlan-interface 103
[SwitchC-Vlan-interface103] multicast ipv6 boundary scope 4
[SwitchC-Vlan-interface103] quit
[SwitchC] interface vlan-interface 106
[SwitchC-Vlan-interface106] multicast ipv6 boundary scope 4
[SwitchC-Vlan-interface106] quit
# On Switch D, configure VLAN-interface 107 to be the boundary of admin-scope zone 2.
<SwitchD> system-view
[SwitchD] interface vlan-interface 107
[SwitchD-Vlan-interface107] multicast ipv6 boundary scope 4
[SwitchD-Vlan-interface107] quit
4. Configure C-BSRs and C-RPs.
# On Switch B, configure the service scope of RP advertisements, and configure VLAN-interface 101 as
a C-BSR and C-RP of admin-scope zone 1.
[SwitchB] pim ipv6
[SwitchB-pim6] c-bsr scope 4
[SwitchB-pim6] c-bsr 1002::2
[SwitchB-pim6] c-rp 1002::2 scope 4
[SwitchB-pim6] quit
# On Switch D, configure the service scope of RP advertisements, and configure VLAN-interface 104 as
a C-BSR and C-RP of admin-scope zone 2.
[SwitchD] pim ipv6
[SwitchD-pim6] c-bsr scope 4
[SwitchD-pim6] c-bsr 3002::2
[SwitchD-pim6] c-rp 3002::2 scope 4
[SwitchD-pim6] quit
# On Switch F, configure VLAN-interface 109 as a C-BSR and C-RP in the global scope zone.
<SwitchF> system-view
[SwitchF] pim ipv6
[SwitchF-pim6] c-bsr scope global
[SwitchF-pim6] c-bsr 8001::1
[SwitchF-pim6] c-rp 8001::1
[SwitchF-pim6] quit
5. Verify the configuration.
To view the BSR election information and the C-RP information on a switch, use the display pim ipv6
bsr-info command. For example:
# View the BSR information and the locally configured C-RP information on Switch B.
[SwitchB] display pim ipv6 bsr-info
Elected BSR Address: 8001::1
Priority: 64
Hash mask length: 126
State: Accept Preferred
Scope: 14
Uptime: 00:01:45
Expires: 00:01:25