H3C Technologies H3C Intelligent Management Center - Manual (Page 37)

28
b. Enter the start and end IP addresses.
When you enter the two IP addresses, follow these guidelines:
The IPv4 addresses must be complete.
The start IP address cannot be higher than the end IP address.
The two IP addresses must be on the same network with a 24-bit mask, which means the first
three octets of the IP addresses must be the same.
c. Click OK to return to the page for adding devices. The added devices appear in the Device List.
d. Click Clear All in Device List to remove all devices from the device list. To delete a device, click
the Delete icon .
7. Click OK. The configuration result page appears.
8. To return to the device list, click Back.
Importing devices
To import devices in batches:
1. Click the User tab.
2. On the navigation tree, select Device User Policy > Device List.
The Device List displays all devices.
3. In the Device List area, click Batch Import.
4. Click Browse next to the Import File field.
The Choose File window appears. Browse to the target file that contains the device information.
The file must be a text file with columns separated by delimiters. The system automatically
populates the field with the file path and name.
5. Select a separator for the file. Options are:
{
Space
{
Tab
{
Comma (,)
{
Colon (:)
{
Pound (#)
{
Dollar sign ($)
6. Click Next.
The Basic Information page appears.
7. Configure the following parameters:
{
Device IP—IP address of the device. If the nas-ip command is configured on the device at the CLI,
the imported device IP must be the same as the configuration on the device. If the nas-ip
command is not configured on the device at the CLI, the imported device IP must be the same
as the IP address of the interface that connects the device to TAM. This field must be imported
from the file to be imported. You must select column n as the device IP.
{
Shared Key—Enables the device and TAM to authenticate each other. The value must be the
same as the value configured on the device at the CLI. Select the column in the file that contains
the shared key, or select Not Import from File to manually set the same shared key for all
imported devices.