Roland SH-4d Digital Desktop Synthesizer - Manual (Page 107)

MFX Parameters
107
StepFlanger
This is a flanger in which the flanger pitch changes in steps.
The speed at which the pitch changes can also be specified in terms of a note-value of a specified tempo.
Parameter Value Explanation
Type
OFF, LPF, HPF Filter type
OFF: No filter is used
LPF: Cuts the frequency range above the Cutoff
Freq
HPF: Cuts the frequency range below the Cutoff
Freq
Cutoff
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000,
2500, 3150, 4000, 5000, 6300, 8000 [Hz]
Basic frequency of the filter
Pre Delay
0.0–100 [ms] Adjusts the delay time from the direct sound until
the flanger sound is heard.
Rate Sync
OFF, ON If this is ON, the rate synchronizes with the tempo
of the rhythm.
Tempo (Pattern)
Tempo (System) (P.76)
Rate 0.05–10.00 [Hz] Frequency of modulation
Rate Note Note (P.167)
Depth 0–127 Depth of modulation
Phase 0–180 [deg] Spatial spread of the sound
Feedback
-98–+98 [%] Adjusts the proportion of the flanger sound that is
fed back into the effect.
Negative (-) settings will invert the phase.
S.Rate
Sync
OFF, ON If this is ON, the rate synchronizes with the tempo
of the rhythm.
Tempo (Pattern)
Tempo (System) (P.76)
S.Rate 0.10–20.00 [Hz] Rate (period) of pitch change
S.Rate Nt Note (P.167)
Low Gain -15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain -15–+15 [dB] Amount of boost/cut for the high-frequency range
Balance D100 ： 0W ～ D0 ： 100W
Volume balance between the direct sound (D) and
the flanger sound (W)
Level 0 ～ 127
Output Level