Roland SH-4d Digital Desktop Synthesizer - Manual (Page 123)

MFX Parameters
123
W Saturator (Warm Saturator)
This is a variety of saturator, and is distinctive for its warmer sound.
Parameter Value Explanation
LowFreq
20–16000 [Hz] Input filter (low range)
Boosts/cuts the sound below the specified frequency.
LowGain
-24.0–+24.0 [dB] Input filter (low range)
Amount of boost/cut
Hi Slope
THRU, -12dB, -24dB Amount of attenuation per octave
THRU: No attenuation
-12 dB: Gentle
-24 dB: Steep
Hi Freq
20–16000 [Hz] Input filter (high range)
Boosts/cuts the sound above the specified frequency.
Pre1 Type
THRU, LPF, HPF, LSV, HSV Types of filter that precedes the distortion processing
THRU: No filter is applied
LPF: A filter that passes the sound below the specified frequency
HPF: A filter that passes the sound above the specified frequency
LSV: A filter that boosts/cuts the sound below the specified frequency
HSV: A filter that boosts/cuts the sound above the specified frequency
Pre1Freq 20–16000 [Hz] Frequency at which the pre-distortion filter operates
Pre1Gain -24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Drive 0.0–48.0 [dB] Strength of distortion
Post1 Type THRU, LPF, HPF, LSV, HSV Type of filter 1 which follows the distortion processing
Post1Frq 20–16000 [Hz] Frequency at which post-distortion filter 1 operates
Post1Gain -24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Post2 Type THRU, LPF, HPF, LSV, HSV Type of filter 2 which follows the distortion processing
Post2Frq 20–16000 [Hz] Frequency at which post-distortion filter 2 operates
Post2Gain -24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Post3 Type
THRU, LPF, HPF, BPF, PKG Type of filter 3 which follows the distortion processing
THRU: No filter is applied
LPF: A filter that passes the sound below the specified frequency
HPF: A filter that passes the sound above the specified frequency
BPF: A filter that passes only the specified frequency
PKG: A filter that boosts/cuts the specified frequency
Post3Frq 20–16000 [Hz] Frequency at which post-distortion filter 3 operates
Post3Gain -24.0–+24.0 [dB] For the PKG type, the amount of boost/cut
Post3 Q 0.5–16.0 Width of the frequency range affected by the filter
Sense -60.0–0.0 [dB] Adjust this value so that the sound is not made louder when distortion is applied.
PostGain -48.0–+12.0 [dB] Gain following distortion processing
Balance D100: 0W–D0: 100W Volume balance between the dry sound (D) and effect sound (W)
Level 0–127 Output Level