Roland SH-4d Digital Desktop Synthesizer - Manual (Page 163)

MFX Parameters
163
Parameter Value Explanation
Flg Bal
D100: 0W–D0:
100W
Adjusts the volume balance between the sound that is sent through the flanger (W) and the
sound that is not sent through the flanger (D).
Level 0–127 Output Level
Enhncr -> Dly (Enhancer -> Delay)
Parameter Value Explanation
Enh Sens 0–127 Sensitivity of the enhancer
Enh Mix 0–127 Level of the overtones generated by the enhancer
Delay
Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System) (P.76)
D. Time 1–2600 Delay time from when the original sound is heard to when the
delay sound is heard
D.Time Nt Note (P.167)
Delay Fbk
-98–+98 [%] Adjusts the proportion of the delay sound that is fed back into the
effect.
Negative (-) settings will invert the phase.
Dly HF
200, 250, 315, 400, 500, 630, 800, 1000, 1250,
1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000,
BYPASS [Hz]
Adjusts the frequency above which sound fed back to the effect
will be cut. If you do not want to cut the high frequencies, set this
parameter to BYPASS.
Dly Bal
D100: 0W–D0: 100W Adjusts the volume balance between the sound that is sent
through the delay (W) and the sound that is not sent through the
delay (D).
Level 0–127 Output Level
Chorus -> Dly (Chorus -> Delay)
Parameter Value Explanation
Cho
PreDly
0.0–100 [ms] Adjusts the delay time from the direct sound until the chorus
sound is heard.
Cho Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)