Roland SH-4d Digital Desktop Synthesizer - Manual (Page 158)

MFX Parameters
158
Parameter Value Explanation
Negative (-) settings will invert the phase.
Dly HF
200, 250, 315, 400, 500, 630, 800, 1000,
1250, 1600, 2000, 2500, 3150, 4000, 5000,
6300, 8000, BYPASS [Hz]
Frequency at which the high-frequency portion of the delay sound
will be cut (BYPASS: no cut)
Dly Bal
D100: 0W–D0: 100W Adjusts the volume balance between the sound that is sent through
the delay (W) and the sound that is not sent through the delay (D).
Level 0–127 Output Level
EP -> Tremolo (EP Amp Simulator -> Tremolo)
Parameter Value Explanation
Type
Type of amp
OLDCASE A standard electric piano sound of the early 70s
NEWCASE A standard electric piano sound of the late 70s and early 80s
WURLY A standard electric piano sound of the 60s
Bass -50–+50 Amount of low-frequency boost/cut
Treble -50–+50 Amount of high-frequency boost/cut
Tremolo Sw OFF, ON Tremolo on/off
Tremolo Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System) (P.76)
T. Speed 0.05–10.00 [Hz] Rate of the tremolo effect
T.Spd Nt Note (P.167)
Trm Depth 0–127 Depth of the tremolo effect
Trm Duty -10–+10 Adjusts the duty cycle of the LFO waveform used to apply tremolo.
Sp Type
LINE, OLD, NEW, WURLY, TWIN Type of speaker
If LINE is selected, the sound will not be sent through the speaker simulation.
OD Switch OFF, ON Overdrive on/off
OD Gain 0–127 Overdrive input level
OD Drive
0–127 Degree of distortion
Also changes the volume.
Level 0–127 Output Level