Roland SH-4d Digital Desktop Synthesizer - Manual (Page 168)

PATTERN CHORUS
168
PATTERN CHORUS
Parameter Value Explanation
Type Ø “ Chorus Parameters (P.168)”
Switch OFF, ON Turns the chorus on/off.
Chorus parameters
Sets the parameters of the selected chorus type.
The available parameters differ depending on the type of chorus you selected in Type.
Ø “ Chorus Parameters (P.168)”
Level 0–127 Specifies the output level of the sound with chorus applied.
Rev Send 0–127 Specifies the send level to the reverb.
Chorus Parameters
OFF
Turns the effect off.
Chorus
This is a stereo chorus.
Parameter Value Explanation
Rate 0–127 Adjusts the frequency of modulation.
Depth 0–127 Adjusts the depth of modulation.
Feedback 0–127 Adjusts the level of chorus sound that’s returned to the input.
CE-1
This models the classic BOSS CE-1 chorus effect unit.
It provides a chorus sound with a distinctively analog warmth.
Parameter Value Explanation
Intensity 0–127 Adjusts the chorus depth.
SDD-320 (DIMENSION D)
This models Roland’s DIMENSION D (SDD-320).
It provides a clear chorus sound.
Parameter Value Explanation
Mode 1, 2, 3, 4, 1+4, 2+4, 3+4 Switches the mode.
Delay
This is a stereo delay.
Parameter Value Explanation
Dly Sync OFF, ON If this is ON, the delay synchronizes with the tempo.
Dly Msec 1–1300 Adjusts the delay time from the direct sound until the delay sound is heard.
Dly Note Note
Feedback
-98–+98 [%] Adjusts the proportion of the delay sound that is fed back into the effect. Negative (-) settings
will invert the phase.
HF Damp
200–8000 [Hz],
BYPASS (*1)
Adjusts the frequency above which sound fed back to the effect is filtered out. If you don’t want
to filter out any high frequencies, set this parameter to BYPASS.