Inputting/editing velocity and gate length – Roland SH-4d Digital Desktop Synthesizer User Manual
Page 60
Creating a Pattern (Step Sequencer)
60
Inputting/Editing Velocity and Gate Length
For tone parts
1.
Long-press the [1]–[16] buttons to bring up the STEP EDIT screen. While holding down the [1]–[16]
buttons, press one of the [
д
] [
е
] buttons.
The STEP EDIT screen stays open.
Without pressing the [
д
] [
е
] buttons, take your finger off the [1]–[16] buttons to close the STEP EDIT screen.
2.
Press the [
д
] [
е
] buttons to select the note whose velocity or gate length you wish to edit.
Turn the [1] knob to edit the velocity.
Turn the [2] knob to edit the gate length.
●
When the gate length is set to maximum, the tie is connected to the note in the next step.
●
The actual gate length when the pattern plays back equals the gate length set in the respective pattern plus the “Gate
Length” value set on the PATTERN SETTINGS screen.
For details, refer to “
(P.66)”.