Furuno RC-1500-1T - Manual (Page 121)

4-45
11. Do one of the following depending on the message shown at step 10.
Waiting for acknowledge
1) After the timer counts down to zero the following message appears.
PSTN connection
call in progress!
TIME TO GO: 25S
DSC FREQ : 12577.5 KHZ
FROM COAST : 001234567
TEL No. : 1234567890123456
2) After the connection call is sent the following message appears.
Waiting for acknowledgement
Waiting for
acknowledgement.
TIME TO GO: 25S
DSC FREQ : 12577.5 KHZ
FROM COAST : 001234567
TEL NO. : 1234567890123456
TELEPHONE CH 12001
3) After the timer counts down to zero one of the following messages appears.
PSTN call connected.
DSC FREQ : 12577.5 KHZ
TO COAST : 001234567
TEL NO. : 1234567890123456
TELEPHONE CH 12001
PSTN call connected PSTN connection call in progress PSTN end of call
PSTN connection
call in progress!
TIME TO GO: 25S
DSC FREQ : 12577.5 KHZ
FROM COAST : 001234567
TEL NO. : 1234567890123456
PSTN end of call
in progress!
TIME TO GO: 7S
TO COAST : 001234567
TEL NO. : 1234567890123456
TELEPHONE CH 12001
DSC FREQ :
12577.5 KHZ
PSTN call connected: Your phone rings; pick up the handset and communication with
receiving station.
PSTN connection call in progress!: This means coast station has switched DSC
frequency. (If the channel cannot be used the message “PSTN end of call in progress!”
appears. In this case, start this procedure again.) If the channel assigned is OK the
message “Waiting for acknowledgment.” appears.
PSTN end of call in progress!: The channel could not be used. Press the [CANCEL]
key to return to the DSC standby screen. Repeat this procedure to send the call again.